Measurements technics
Measurements technics - oscilloscopes, voltmeters, multimeters, generators - review, tests
- Cool Power with D-Watt 24.09.2017It has been nearly three years since we presented our last power amplifier project in Elektor - the Q-Watt Audio Power Amplifier [1]. That was a standard class AB power amplifier with high output power and low distortion. Since then a large number of audio enthusiasts have built their own copy of that amplifier. With the design presented here, we…
- DAB+ Antenna Diplexer. Add digital reception to your car radio 09.09.2017If you feel like replacing the VHF-FM radio in your car with something more modern offering DAB+ reception too, you'll discover that combination receivers have two separate antenna inputs. That's because two individual antennas are required. But this RF combiner makes it possible to connect both inputs to one standard car antenna.
- IoT Shield for Arduino 24.08.2017This handy Arduino Uno R3 compatible shield is intended for simple control applications in and around the house. When the system is connected to the Internet, the label "Internet of Things" (IoT) becomes applicable.
- Sensors make Sense. For Arduino and more 03.08.2017Sensors are either analog or digital. Analog values are read in via an A-D input, whereas for digital signals a simple Port connection frequently adequate. In some cases, however, sensors have dual outputs, one analog and one digital.
- Matchbox Capacitor Tester 09.04.2017Checking of an electrolytic capacitor without an LCR meter is not free from hassles. Here is a simple solution for checking the serviceability of a capacitor.
- Tester for 555 Timer and 741 Op-amp ICs 12.03.2017Sometimes you do not get proper output from a circuit due to faulty ICs. This circuit can test timer 555 and op-amp 741 ICs, which are commonly used in projects, to save you from this problem.
- Real-Time Clock with Temperature Logger 10.03.2017Presented here is a simple realtime clock with temperature logger. The project shows time, date and real-time temperature on the LCD. The logger records the maximum and minimum temperature for each day and can keep entries for 51 days. The recorded temperatures can be viewed any time together with the dates. The temperature is sensed via…
- Active RF Detector Probe for DMMS 18.06.2016This low-cost detector probe allows you to measure RF signals from below 100kHz up to over 1GHz with your DMM for signal voltages between about 20mV and 10 V RMS. You can use it with a probe or a sniffer loop and you can even use it to measure the voltage across a coaxial cable load and calculate the RF power.
- Extremely accurate GPS 1pps timebase for A frequency counter 13.04.2016Get maximum accuracy from your 12-Digit Frequency Counter using this GPS lpps Timebase. It connects to the external timebase input of the counter and will let you achieve measurement accuracy close to that of an atomic clock. You can either build it into the frequency counter or use it as a separate module.
- Synchronous and asynchronous counters 09.04.2016LAST month, we looked at some issues which arose from the simulation of a binary counter. A question was posted by perro on the EPE Chat Zone asking if the unwanted behaviour of the circuit was due to a problem with the Circuit Wizard simulation he had used, or was something to do with the circuit itself. Perro’s circuit was an asynchronous ripple…









